Voltage Regulator Board

Camera which is connected to this Voltage regulator is limited to about 8 VDC. This unit has an input voltage of 13.8 VDC and is regulated down to approximately 8 VDC.


Top Inside View

This unit is a 1 Watt Video Transmitter
Transmitter Board is a P.C. Electronics TXA5-RCb ATV Transmitter Board inside an aluminum enclosure purchased from Radio Shack.

Antenna Connector on right is an N type connector.
Video Input Connector on top left is an RCA panel mount.
Power Connector on bottom left is a two pin mic type screw-on connector used for 12 VDC power input.

>
TOP INSIDE VIEW (Reverse)

This unit is a 1 Watt Video Transmitter
Transmitter Board is a P.C. Electronics TXA5-RCb ATV Transmitter Board inside an aluminum enclosure purchased from Radio Shack.

Antenna Connector on left is an N type connector.
Video Input Connector on top right is an RCA panel mount.
Power Connector on bottom right is a two pin mic type screw-on connector used for 12 VDC power input.


REAR VIEW

This unit is a 1 Watt Video Transmitter (Bottom) and a 12 VDC to 8 VDC Voltage Regulator (Top).
Transmitter Board is a P.C. Electronics TXA5-RCb ATV Transmitter Board inside an aluminum enclosure purchased from Radio Shack.


FRONT VIEW

This unit is a 1 Watt Video Transmitter (Bottom) and a 12 VDC to 8 VDC Voltage Regulator (Top).
Transmitter Board is a P.C. Electronics TXA5-RCb ATV Transmitter Board inside an aluminum enclosure purchased from Radio Shack.

More Radio Shack Amateur Television Equipment

ATV Equipment Sources